<\/p>\n\r
The Warning<\/span> page allows you to control some of the warnings that Coverage Validator displays. <\/p>\n\r <\/p>\n\r <\/p>\n\r <\/p>\n\r When working with MAP files the timestamp of a module and its MAP file often differ by many seconds.<\/p>\n\r <\/p>\n\r You can set the maximum acceptable difference between the two timestamps before the MAP file is considered invalid.<\/p>\n\r <\/p>\n\r •<\/span>Threshold<\/span> enter the maximum acceptable difference (the default is 60 seconds) <\/span><\/p> <\/p>\n\r <\/p>\n\r You may see warning dialogs when Coverage Validator receives an error accessing the registry or obtaining debugging privileges.<\/p>\n\r <\/p>\n\r These warnings are enabled by default, but you can opt not to see them:<\/p>\n\r <\/p>\n\r •<\/span>Edit User Permissions Warnings...<\/span> <\/span> <\/span> shows the User Permissions Warnings dialog below <\/span><\/p> <\/p>\n\r <\/p>\n\r <\/p>\n\r The Help button displays the User Permissions<\/a> help topic.<\/p>\n\r <\/p>\n\r <\/p>\n\r <\/p>\n\r <\/p>\n\r When Coverage Validator collects code coverage data and finds filenames without paths the No File Path Warning dialog can be displayed.<\/p>\n\r <\/p>\n\r Without knowing the file path Coverage Validator can\'t inspect the file for source code exclusion<\/a> pragmas, and also can\'t display the source code in any of the displays. <\/p>\n\r •<\/span>If files with no path are found...<\/span> when enabled the No File Path Warning dialog will be displayed when files without a path are found in code coverage data <\/span><\/p> <\/p>\n\r <\/p>\n\r <\/span><\/p>\n\r <\/p>\n\r •<\/span>Edit File Locations...<\/span> displays the File Locations<\/a> settings dialog set to "Source Code" <\/span><\/p> <\/p>\n\r •<\/span>Don\'t show this again...<\/span> turns off the display of this dialog. To re-enable it, select the If files with no path are found...<\/span> check box on the Warnings<\/a> settings. <\/span><\/p> <\/p>\n\r <\/p>\n\r Reset All - <\/span>Resets all<\/span> global settings, not just those on the current page.<\/p>\n\r <\/p>\n\r <\/p>\n\r Reset - <\/span>Resets the settings on the current page.<\/p>\n\r <\/p>\n\r"
})
<\/span><\/h1>\n\r
<\/a>MAP file timestamp threshold<\/span><\/h1>\n\r
<\/span><\/h1>\n\r
<\/a>User permissions warnings<\/span><\/h1>\n\r
<\/span><\/h1>\n\r
See also, the answer to the question about creating Power User accounts on Windows XP<\/a>.<\/h1>\n\r
<\/a>No file path warnings<\/span><\/h1>\n\r
\n\r
\n\rThe solution is to declare where source code (and 3rd party source) is located using the File Locations<\/a> settings.<\/p>\n\r